MacDon D65 SP DHOM - Manual (Page 63)

OPERATION
3. On the right wheel assembly, remove hairpin (A)
from latch.
4. Disengage latch (B) and lift right wheel out of hook and
place on ground as shown. This reduces weight of
assembly and makes adjusting wheel position easier.
5. Support left wheel weight by lifting slightly with one
hand. Pull up on handle (C) to release lock.
6. Lift left wheel to desired height and engage support
channel into slot (D) in upper support.
7. Push down on handle (C) to lock.
8. Lift right wheel back into field position and ensure latch
(B) is engaged.
9. Secure latch with hairpin (A).
Figure 4.19: Right Wheel
10. Support the left wheel assembly’s wheel weight by
lifting slightly with one hand. Pull up on handle (A) to
release lock.
11. Lift wheels to desired height and engage support
channel into slot (B) in upper support.
12. Push down on handle (A) to lock.
Figure 4.20: Left Wheel
13. Lower header to desired cutting height using combine
controls and check load indicator. As an example
the image shows that the wheels are set to a range
between ‘2’ and ‘3’ on load indicator.
Figure 4.21: Load Indicator
169899 51 Revision A