MacDon D65 SP DHOM - Manual (Page 220)

MAINTENANCE AND SERVICING
2. Remove reel endshields and endshield support (C)
from the tail end of the reel at applicable tine
tube location.
NOTE:
There are no endshields on the center disc.
3. Remove bolts (A) securing arm (B) to disc.
IMPORTANT:
Note the hole locations in arm and disc and ensure bolts
are reinstalled at original locations.
Figure 6.169: Tail End
4. Release bushing clamps (A) using a small screwdriver
to separate the serrations. Pull clamp off tine tube.
Figure 6.170: Bushing Clamp
5. Rotate arm (A) clear of disc and slide arm inboard off
bushing and remove bushing halves (B). If required
remove the next tine or plastic finger, so that the arm
can slide off the bushing. Refer to:
• Removing Plastic Fingers, page 206
• Removing Steel Tines, page 205
Figure 6.171: Bushing
169899 208 Revision A