Installing double reel u-joint – MacDon D65 SP DHOM User Manual
Page 238
3.
Remove six bolts (A) attaching U-joint flange (B) to
driven sprocket (C).
4.
Remove U-joint.
NOTE:
Right hand reel may need to be moved sideways for
U-joint to clear reel tube.
Figure 6.219: U-Joint
Installing Double Reel U-Joint
To install the U-joint, follow these steps.
NOTE:
Right hand reel may need to be moved sideways for
U-joint to clear reel tube.
1.
Position U-joint flange (B) onto driven sprocket (C) as
shown. Install six bolts (A) and hand-tighten. Do NOT
torque at this time.
Figure 6.220: U-Joint
2.
Position right-hand reel tube against reel drive and
engage stub shaft into U-joint pilot hole.
3.
Rotate reel until holes in end of reel tube and U-joint
flange (B) line up.
4.
Install four bolts (A) and torque to 70–80 ft·lbf
(95–108 N·m).
Figure 6.221: U-Joint
169899
226
Revision A