MacDon D65 SP DHOM User Manual
Page 221
Cam End Bushings
NOTE:
Removing cam end bushings requires that the tine tube
be moved through the disc arms to expose the bushing.
6.
At the cam end, remove endshields and endshield
support (A) at applicable tine tube location on the
cam end.
Figure 6.172: Cam End
7.
At the tail end, remove reel endshields and endshield
support (C) at applicable tine tube location.
NOTE:
There are no endshields on the center discs.
8.
At the tail and center discs, remove bolts (A) securing
arm (B) to disc.
Figure 6.173: Tail End
9.
At the tine tube support (if installed) locations ,either
release the bushing clamps or disconnect the support
channels from the tube support, depending on which
tine tube is being moved. Three tine tubes (B) require
that the channels be disconnected and two (C) require
only to remove the bushing clamp.
Figure 6.174: Tine Tube Supports
169899
209
Revision A