MacDon D65 SP DHOM - Manual (Page 107)

OPERATION
2. Remove pin (A) and store at (B).
3. Pull handle (C) up to release.
4. Lift wheel to desired height and engage support
channel into slot (D) in vertical support.
5. Push down on handle (C) to lock.
Figure 4.81: Left Rear Wheel
6. Pull pin (A) on brace (B) on the left hand wheel in front
of the cutterbar. Disengage brace from cutterbar and
lower the brace against axle (C).
7. Remove pin (D), lower the support (E) onto axle, and
reinsert pin into support.
8. Swing axle (C) clockwise towards the rear of the
header.
Figure 4.82: Right Rear Axle
169899 95 Revision A