MacDon D65 SP DHOM - Manual (Page 223)

MAINTENANCE AND SERVICING
Tine Tube Support Bushings (If installed)
If the tine tube reinforcing kit is installed:
13. Locate the support (A) that requires a new bushing.
14. Remove four bolts (B) securing channels (C) to support
(A).
15. If finger (D) is too close to support to allow access
to bushing, remove screw (E) and remove finger (D).
Refer to
Removing Plastic Fingers, page 206 .
Figure 6.178: Tine Tube Support
16. Release bushing clamp (A) using a small screwdriver
to separate the serrations. Move clamp clear of
bushing.
Figure 6.179: Bushing Clamp
Figure 6.180: Bushing Clamp
169899 211 Revision A