MacDon D65 SP DHOM - Manual (Page 127)

MAINTENANCE AND SERVICING
6.2.2 Recommended Fluids and Lubricants
Your machine can operate at top efficiency only if clean lubricants are used.
• Use clean containers to handle all lubricants.
• Store in an area protected from dust, moisture, and other contaminants.
Lubricant Specification Description Use Capacities
Grease
SAE
Multi-Purpose
High Temperature Extreme
Pressure (EP2) Performance
With 1% Max.
Molybdenum
Disulphide (NLGI Grade 2)
Lithium Base
As Required Unless
Otherwise Specified.
—
Knife Drive Box 2.3 quarts (2.2 liters)
Gear
Lubricant
SAE 85W-140 API Service Class GL-5
Main Drive Gearbox 5 pints (2.5 liters)
6.2.3 Torque Specifications
The following tables give correct torque values for various bolts, cap screws, and hydraulic fittings.
• Tighten all bolts to the torques specified in chart (unless otherwise noted throughout this manual).
• Replace hardware with the same strength and grade bolt.
• Check tightness of bolts periodically, using the tables below as a guide.
• Torque categories for bolts and cap screws are identified by their head markings.
SAE Bolt Torque Specifications
Torque values shown in this table are valid for non-greased, or non-oiled threads and heads. Therefore, do NOT
grease or oil bolts or cap screws unless otherwise specified in this manual.
Table 6.1 SAE Grade 5 Bolt and Grade 5 Free
Spinning Nut
Torque (ft·lbf)
(*in·lbf)
Torque (N·m)
Nominal
Size (A)
Min. Max. Min. Max.
1/4-20 *106 *117 11.9 13.2
5/16-18 *218 *241 24.6 27.1
3/8-16 32 36 44 48
7/16-14 52 57 70 77
1/2-13 79 87 106 118
9/16-12 114 126 153 170
5/8-11 157 173 212 234
3/4-10 281 311 380 420
7/8-9 449 496 606 669
1-8 611 676 825 912
Figure 6.1: Bolt Grades
A - Nominal Size B - SAE-8
C - SAE-5 D - SAE-2
169899 115 Revision A