MacDon D65 SP DHOM - Manual (Page 247)

MAINTENANCE AND SERVICING
2. Remove four bolts (A) attaching reel tube to U-joint (B).
Figure 6.241: U-Joint
3. Move right-hand reel sideways to separate the reel
tube (A) and U-joint (B).
4. Remove the chain (C).
5. Route new chain (C) over U-joint (B) and locate
on sprockets.
Figure 6.242: Replacing Chain
6. Position right-hand reel tube (A) against reel drive and
engage stub shaft into U-joint (B) pilot hole.
7. Rotate reel until holes in end of reel tube and U-joint
line up.
8. Apply Loctite
®
#243 (or equivalent) to four 1/2 in.
bolts (A) and install with lock washers.
9. Torque to 75–85 ft·lbf (102–115 N·m).
Figure 6.243: U-Joint
169899 235 Revision A