MacDon D65 SP DHOM - Manual (Page 203)

MAINTENANCE AND SERVICING
Installing Draper Idler Roller
1. Position stub shaft in idler roller in forward arm (B) on
deck.
2. Push on roller to deflect forward arm slightly so that
stub shaft at rear of roller can be slipped into rear arm
(C).
3. Install bolts (A) with washers, and torque to 70 lb-ft
(93 N·m).
4. Wrap the draper over the idler roller, re-connect it and
set the tension. See
6.7.2 Installing Drapers, page 176 .
5. Run machine to verify that draper tracks correctly.
Adjust tracking if required. See
6.7.6 Adjusting Header
Draper Tracking, page 184 .
Figure 6.131: Idler Roller
Draper Drive Roller
Removing Draper Drive Roller
1. If draper connector is not visible, engage the header until the connector is accessible, preferably close to the
outboard end of the deck.
DANGER
Engage header safety props and reel props before working under header or reel.
2. Raise header and reel, shutdown the engine.
3. Engage header lift cylinder safety props and reel lift cylinder safety props.
4. Loosen draper by turning adjuster bolt (A)
counterclockwise.
Figure 6.132: Tensioner
169899 191 Revision A