MacDon D65 SP DHOM - Manual (Page 242)

MAINTENANCE AND SERVICING
Removing Reel Drive Motor
To remove the reel drive motor from a single or double reel header, follow these steps:
1. Disconnect hydraulic lines (A) at motor (B). Cap or plug
open ports and lines.
2. Slide motor (B) and motor mount (C) up or down so that
attachment bolts (D) are exposed in holes and slots in
back plate.
Figure 6.229: Reel Drive Motor
3. Remove four nuts (A) and attachment bolts and
remove motor (B) from motor mount (C). Retrieve the
spacer (if installed) from between the motor (B) and
motor mount (C).
Figure 6.230: Reel Drive Motor
169899 230 Revision A