MacDon D65 SP DHOM - Manual (Page 253)

MAINTENANCE AND SERVICING
Tightening Drive Chain
1. Ensure the six bolts (B) securing motor mount to chain
case are loose.
2. Slide motor and motor mount upwards until chain (A)
is tight, and tighten bolts (nuts on backside).
3. There should be 1/8 in. (3 mm) of slack in the chain.
Adjust if necessary.
4. Torque bolts (B) to 54 lbf·ft (73 N·m).
Figure 6.258: Reel Drive
Installing Drive Cover
Install reel drive cover as follows:
1. For SINGLE REEL DRIVE, position reel drive cover (A)
to the reel drive and secure with four bolts (B).
Figure 6.259: Single Reel Drive Cover
2. For DOUBLE REEL DRIVE, position the lower cover
(C) first (if removed) and secure with three bolts (D).
Install upper cover (A) using the six bolts (B).
Figure 6.260: Double Reel Drive Cover
169899 241 Revision A