Rockwell Automation 2090 Ultra3000 Installation Manual - Manual (Page 184)

Publication 2098-IN003E-EN-P — April 2004
C-6 Catalog Numbers and Accessories
SERCOS Interface Fiber-Optic Cables
Use the following table to identify the SERCOS interface fiber-optic
plastic cables for your Ultra3000 (connectors at both ends).
Note: Cable length (x-x) is in meters. Plastic cable is available in lengths up to 32 m (105.0 ft). Glass cable is
available in lengths up to 200 m (656.7 ft).
Drive End Connector Kits
Use the following table to identify the drive-end connector kit for your
serial, feedback, and I/O cable. Refer to the chapter Ultra3000
Connector Data for pin signal, and wiring information.
The following table lists Amp drive cable connectors that are not
available from Rockwell Automation. Please contact Amp at
1-800-522-6752 or a distributor for additional information.
1
Accepts 22-28 AWG wire.
2 Accepts 20-24 AWG wire.
3 Ferrules are only required for use with shielded backshell kits.
Description Catalog Number
SERCOS fiber-optic plastic cable (for use inside enclosure only) 2090-SCEPx-x
SERCOS fiber-optic plastic (PVC) cable (for use outside enclosure) 2090-SCVPx-x
SERCOS fiber-optic plastic (nylon) cable (for use outside enclosure in harsh
environments)
2090-SCNPx-x
SERCOS fiber-optic glass (PVC) cable 2090-SCVGx-x
Description Catalog Number
Drive Connector Kit, 9-pin D-shell, serial cable to drive (CN3) 2090-UXCK-D09
Drive Connector Kit, 15-pin high density D-shell, feedback cable to drive
(CN2)
2090-UXCK-D15
Drive Connector Kit, 44-pin high density D-shell, I/O cable to drive (CN1) 2090-U3CK-D44
Connector
Components
CN1 Controller
44-Pin
High-Density
D-Shell
CN2 Motor Feedback
15-Pin
High-Density
D-Shell
CN3 Serial
9-Pin
Standard-Density
D-Shell
Drive Connector 748366-1 748364-1 205204-4
Crimp Pin
Contacts
748333-4
1
748333-4
1
5-66506-7
2
Unshielded
Backshell Kit
748678-3 748678-1 748678-1
Shielded
Backshell Kit
745173-3 745171-5 745171-5
Ferrules
3 745508-1 745508-6 745508-6