Rockwell Automation 2711E-ND7 PanelView File Transfer Utility User Manual - Manual (Page 15)

1–7 Introducing the PanelView e Transfer Utility 32
If your version of INTERCHANGE is earlier than 6.1.0, you must
view and configure the ports outside of the PanelView 1200/1400e
Transfer Utility. Refer to your INTERCHANGE user documentation.
Again, make sure the port you select is configured correctly for your
communication device and settings.
PanelView 1200/1400e Transfer Utility and WINtelligent LINX
The PanelView 1200/1400e Transfer Utility Version 3 supports
WINtelligent LINX network drivers, Version 5.20.00 or later. The
PanelView 1200/1400e Transfer Utility supports a subset of the
WINtelligent LINX drivers—those used for appropriate DH+,
ControlNet, and serial transfers. You can use these drivers to transfer
files over DH+, ControlNet, RIO Pass-Through, or serial connection
networks. Contact your Allen-Bradley Sales Representative for more
information on WINtelligent LINX.
To use the WINtelligent LINX drivers, install them before setting up
transfer communications. The PanelView 1200/1400e Transfer
Utility displays the WINtelligent LINX drivers as driver options, but
you can use them only if they are installed. Make sure the driver you
select is configured correctly for the communication device and
settings. You can open the WINtelligent LINX configuration utility
from the Transfer Utility to configure your selected driver.
Refer to the WINtelligent LINX for Allen-Bradley Programmable
Controllers User’s Guide (Publication Number 9352-WABUG) for
complete information.
Important: The PanelView 1200/1400e Transfer Utility works with
INTERCHANGE only, WINtelligent LINX only, or
with both INTERCHANGE and WINtelligent LINX
installed on the same computer.
FTU Version 3