Rockwell Automation 2711E-ND7 PanelView File Transfer Utility User Manual - Manual (Page 64)

4–2 Downloading 1000e/1200e/1400e Application Files
To prepare the PanelView terminal for a serial download:
1. Using the hardware keyswitch or the Goto Configure Mode
button, switch the PanelView terminal to the Configure mode.
2. In the Terminal Configuration screen, choose the Transfer Setup
button to display the Transfer Setup screen.
3. To change the settings, choose the Baud Rate, Parity, or Error
buttons to move the check mark to the setting you want.
•
Baud Rate
ĊThe speed at which data is transmitted over the
serial cable. The default setting for a serial transfer is
9600 baud.
•
Parity
ĊUsed to check for accurate transmission of the data
between the development computer and terminal. The default
setting is None.
•
Error
ĊUsed to check for errors in the data transmission.
Error checking is either
CRC
Ċcyclical (or cyclic) redundancy check.
BCC
Ċblock check character. BCC is the default setting.
The settings that are defined in the Transfer Setup screen must
match the Transfer Utility’s settings.
4. When you have selected the required settings, choose OK to exit
this screen.
5. To download an application serially, in the Terminal
Configuration screen, choose the Transfer Application button to
display the Transfer Application screen.