Rockwell Automation 2711E-ND7 PanelView File Transfer Utility User Manual - Manual (Page 38)

2–23 Working with the PanelView e Transfer Utility 32
Publication 2711E-UM003B–EN–P
13. After all the applications have completed installing, you are
prompted to reboot your computer. You can reboot immediately
or later, but you must reboot before you can run the Transfer
Utility or other applications successfully.
If you want to upload or download PanelView files over the PLC
networks after you finish installing the Transfer Utility, you also
need to install INTERCHANGE or WINtelligent LINX software.
If you do not have this software, contact Allen-Bradley Technical
Support for assistance.
Do not cancel the installation while it is in progress. If you want to
undo the installation, let the installation finish, then use Uninstall
Transfer Utility to remove all the installed files and to update the
Windows registry.
For information on how to start and exit from the PanelView
1200/1400e Transfer Utility, see the PanelView 1200/1400e Transfer
Utility User Manual (A-B Publication Number 2711E-6.8).
PanelView e Transfer Utility 32 (FTU32) Version 5 is provided in
the Transfer Utility kit (A-B Catalog Number 2711E-ND7) on CD.
You can create your own 3.5-inch floppy disks from the CD. For
instructions on how to create floppy disks of the software from the
CD, refer to the Floppies.txt file, in the root directory of the
PanelBuilder 1400e CD.
To install the FTU32:
1. Start Windows NT or Windows 95. If you’re already in Windows,
close all open Windows applications.
2. Insert the CD in the drive.
3. Browse the CD for file “FTU_V5”. Browse Disk 1. Run
“SETUP.EXE”.
4. The Welcome dialog box for the Transfer Utility recommends
that you close all open Windows applications. If you have done
that, choose Next.
5. In the registration window, enter registration information about
your copy of the FTU32. Registration information is on the
software registration card in your PanelBuilder 1400e or Transfer
Utility package.
6. Choose the drive and directory in which the FTU32 will be
installed. By default, this is C:\AB\PB1400E\FTU32. To change
the destination drive or directory, type the new drive and/or
directory in the Program Files box. Then choose Next.
Installing the FTU32 from
the “PanelView 1200/1400e
Transfer Utilities” CD on
Windows NT or
Windows 95