Rockwell Automation 2711E-ND7 PanelView File Transfer Utility User Manual - Manual (Page 63)

Chapter
4
Downloading
1000e/1200e/1400e
Application Files
This chapter describes how to download application files using the
various transfer methods described in Chapter 2, Working with the
PanelView e Transfer Utility 32.
For file transfers over ControlNet, DH+, or Remote I/O
Pass-Through, be sure the PanelView terminal address is correct,
otherwise the transfer could corrupt data used by another device on
the network, such as the PLC.
You can download files using either a serial connection, a network
connection, or a Remote I/O connection. For serial transfers, you
must connect the PanelView terminal to a computer with the
Upload/Download cable (Allen-Bradley Catalog Numbers
2706-NC13, 2711-NC13, 2711-NC14 for PanelView 1000e
terminals; 2711-NC1 for PanelView 1200e/1400e terminals). For
network transfers, you must connect the PanelView terminal to the
computer over a DH+ or ControlNet network. For Remote I/O
transfers, you must connect the PanelView terminal to the PLC over
a Remote I/O network, and connect the PLC to the computer over a
DH+, ControlNet, or Ethernet network.
To download application files, you must complete these steps in
order:
•
prepare the PanelView terminal for the download. This section
explains how to prepare a PanelView terminal for a serial,
network, or Remote I/O Pass-Through download.
•
configure the PanelView e Transfer Utility 32 for the download
•
initiate the application file download
Downloading PanelView
1000e/1200e/1400e
Application Files