Rockwell Automation 2711E-ND7 PanelView File Transfer Utility User Manual - Manual (Page 53)

3–7 Uploading 1000e/1200e/1400e Application Files and Alarm History Files
If you want the file to upload with the same name as the selected
upload file, then clear the Prompt Upload Destination box.
If you want to enter a new name for the uploaded file, select
Prompt Upload Destination. Windows NT or Windows 95 file
naming restrictions apply. The file name can exceed 8 characters,
but the PanelView firmware truncates file names that exceed 8
characters.
5. Click OK to save your settings and exit from the File Transfer
Options dialog box.
6. Configure communications settings for the transfer following
instructions in Chapter 5, Configuring Communications Settings
for 1000e/1200e/1400e Application Transfers.
7. To save your settings, choose System Options from the Options
menu, or from the toolbar.
In the General tab of the System Options dialog box, select
Auto-Save All Settings to automatically save all settings when
you exit. You only need to select this check box once, because
your selection becomes the application default.
If the Auto-Save All Settings option is not selected, there is a
Save Settings button in the main download dialog box. If
Auto-Save All Settings box is selected, the Save Settings button
is hidden.
To initiate the application file upload:
" Choose the Start Upload button.
A progress dialog box appears that shows the status of the upload.
If an error occurs during the upload, see Chapter 6,
Troubleshooting for the PanelView e Transfer Utility 32.