Rockwell Automation 2711E-ND7 PanelView File Transfer Utility User Manual - Manual (Page 81)

5–9 Configuring Communications Settings for 1000e/1200e/1400e Application Transfers
3. Select the Configure Driver button.
For Serial 1 or Serial 2, the Communication Driver Configuration
dialog box appears.
4. Define the settings in the Communication Driver Configuration
dialog box as follows:
Baud
Specify the data-transfer rate between your computer and the
PanelView terminal. This must match the baud rate configured
for the PanelView terminal. The default setting is 9600.
Port
Specify COM1, COM2, COM3, or COM4 as the serial port used
to connect the serial cable to the PanelView terminal. The default
setting is COM1.
Parity
Specify None or Even for the type of error-checking to be used.
This must match the parity configured for the PanelView
terminal. The default setting is None.
Error
Specify the error-detection protocol used by the device. BCC is
Block Check Character and CRC is Cyclic Redundancy Check.
This must match the error-checking protocol configured for the
PanelView terminal. The default setting is BCC.
For details about PanelView terminal transfer configuration
settings, see “Transferring Application Files” in Chapter 5,
“Configuring PanelView Terminals,” in your PanelView 1000e,
1200e, and 1400e Operator Terminals User Manual (Publication
Number 2711E-6.17).