Install 2s-2600 lh clutch, 50 i n – Great Plains Electric Clutch Package User Manual
Page 13
Great Plains Manufacturing, Inc.
Update 2S-2600 Left Hand Drive
9
03/24/2009
195-073M
Install 2S-2600 LH Clutch
25. Select one new:
402-025S LOCK COLLAR, 7/8 HEX W/ SET SC
which, if not pre-assembled, consists of:
1
402-058D COLLAR LOCK 7/8 HEX and
2
801-035C SCREW SET 5/16-18 SKT KP X 3/8
26. Adjust the set screws to clear the collar hex hole,
and place the collar onto the new drive shaft
.
Do not tighten the set screws at this time.
27. Select two new:
804-061C WASHER MACH 1.50 X 1.00 X 18GA
Place them on the shaft
28. Select one new:
Place it on the shaft
29. Select the clutch
assembled at step 18. With the
sprocketed end toward the left (toward bearings),
place it on the shaft
, and into the Drive Type
chain
.
30. Select one each new:
196-877D BUSHING 1 1/8 ODX7/8 HEX BORE
839-956C KEY 1/4 X 3/16 X 3.80
Insert the bushing
31. Align the keyways of the bushing and the Ogura
clutch. Insert the key
32. Select two new:
804-061C WASHER MACH 1.50 X 1.00 X 18GA
Place them on the shaft
33. Select one new:
805-180C PIN ROLL 1/4 X 1 1/2 LG PLT
Drive the pin
into the hole at the right end of the
shaft
, to secure all the components just installed
on the shaft.
34. Slide the lock collar
right until it and the washers
contact the clutch assembly
screws.
Figure 8: 2S-2600
Install LH Clutch
28056
U
D
F
B
L
R
i
n
n