Install 3s-3000f/sgs ctr torque tab, 3s-3000f/sgs center closeout, Update 3s-3000f/sgs right hand drive – Great Plains Electric Clutch Package User Manual
Page 56: Remove 3s-3000f/sgs rh linkage
52
Electric Clutch Package
Great Plains Manufacturing, Inc.
195-073M
03/24/2009
Install 3S-3000F/SGS CTR Torque Tab
Refer to Figure 82
73. Select one new:
195-345D CLUTCH TORQUE ARM TAB
and two sets new:
74. Loosely mount the tab
at the middle bracket.
75. Rotate the clutch
until the torque arm
is in the
large hole in the torque tab
76. Tighten tab bolts
3S-3000F/SGS Center Closeout
77. Re-mount the Drive Type chain (not shown). Engage
idler (not shown) for slack of
1
⁄
2
in (13mm).
78. Re-mount option box jackshaft chain (not shown).
Engage idler (not shown) for slack of
1
⁄
4
in (6mm).
79. Select one new (not shown):
833-088C OGURA CLUTCH JUMPER HARNESS
Connect the jumper to the clutch cable.
Update 3S-3000F/SGS Right Hand
Drive
On this section, two coupled shafts are replaced by a sin-
gle solid shaft.
Remove 3S-3000F/SGS RH Linkage
Refer to Figure 83 (which depicts the LH linkage, but the
parts to be removed, and their general arrangement, are
identical on the RH side)
80. Remove individually or as an assembly:
CLUTCH SHUTOFF LINK, 00 SERIES
SPRING EXT 1 1/16 ODX.120WX5.5
These parts are not re-used.
Note: This part may be removed or left in place:
SUBFRM CLUTCH BRKT,SOLID STAND
81. Remove two sets:
and remove the:
Figure 82: 3S-3000F/SGS:
Install CTR Torque Arm Tab
28148
U
D
F
B
L
R
h
t
t
U
D
F
B
L
R
Figure 83: 3S-3000F/SGS:
Remove RH Linkage
17253