Dismount ground drive chain & sprocket, Remove 3s-3000 lh drive shaft, Disassemble 3s-3000 lh clutch – Great Plains Electric Clutch Package User Manual
Page 32: Pre-assemble 3s-3000 lh clutch, Caution, Ef c a k
28
Electric Clutch Package
Great Plains Manufacturing, Inc.
195-073M
03/24/2009
Dismount Ground Drive Chain & Sprocket
Refer to Figure 43
8.
Loosen idler
in gauge wheel assembly.
Lift ground drive chain
off sprocket
.
Do not completely remove the chain.
9.
Drive the roll pin
out of the left end of shaft:
195-189D POWER SHAFT 7/8 HEX LH
This pin is not re-used.
10. Remove and save sprocket
.
Remove
3S-3000 LH
Drive Shaft
CAUTION
!
Shaft
moves, under spring tension, about
1
⁄
2
in (13mm) to
the right as the next pin is removed.
11. Drive out the mid roll pin
. Pin is not re-used.
12. Remove the shaft
from the drill (slide out to
right, with the clutch still mounted).
Disassemble 3S-3000 LH Clutch
13. At the clutch assembly
, remove and save three
sets:
802-004C HHCS 1/4-20X3/4 GR5
804-006C WASHER LOCK SPRING 1/4 PLT
14. The sprocket may still be held by pins. Remove and
save the sprocket:
SPKT 40A23X1.813-1.818 BR/6HOL
Any roll pins present, the shaft, and the balance of
the clutch assembly are not re-used.
Pre-Assemble 3S-3000 LH Clutch
15. Select one each new:
823-231C OGURA CLUTCH
195-347D ELECTRIC CLUTCH ADAPTOR
and three sets new:
802-684C HHCS M8X1.25X55 GR8.8
804-157C WASHER SPRING LOCK M8 PLT
Place the tab end of
down on a work surface.
Note that the 195-347D adaptor
has alternating
smooth and tapped (threaded)
1
⁄
4
in holes.
16. Secure the large end of the 195-347D adaptor
to
the Ogura clutch
with the bolts
and lock wash-
ers
. Torque to specifications (see page 93).
Figure 43: 3S-3000:
Release LH Power Shaft
21627
U
D
F
B
L
R
e
f
c
a
k
a
c
k
e
k
f
Figure 44: 3S-3000:
Disassemble LH Clutch
28106
U
D
F
B
L
R
Figure 45: 3S-3000
Pre-assemble LH Clutch
28144
U
D