Remove 2s-2600 rh clutch, Disassemble 2s-2600 rh clutch, Pre-assemble 2s-2600 rh clutch – Great Plains Electric Clutch Package User Manual
Page 16: Caution, Fd 102
12
Electric Clutch Package
Great Plains Manufacturing, Inc.
195-073M
03/24/2009
Remove 2S-2600 RH Clutch
Refer to Figure 13
CAUTION
!
Shaft
may move, under spring tension, about
1
⁄
2
in (13mm)
to drill right as the next pin is removed.
47. Drive out the mid roll pin
. This pin is not re-used.
48. Move the shaft
to the right. Remove the:
176-042S JAW CLUTCH CW EXT 7/8 HEX
from the shaft
. Leave the shaft in the drill.
Disassemble 2S-2600 RH Clutch
49. From the clutch assembly
, remove and save
three sets:
802-551C HHCS 1/4-20X2 1/4 GR5
804-006C WASHER LOCK SPRING 1/4 PLT
50. The adaptor
and sprocket
may still be held
on by roll pins. Remove and save the adaptor and
sprocket:
195-170D CLUTCH ADAPTOR 7/8 HEX BORE
808-240C
SPKT 40A23X1.813-1.818 BR/6HOL
Any roll pins present, and the balance of the clutch
assembly
, are not re-used.
Pre-Assemble 2S-2600 RH Clutch
51. Select one each new:
823-231C OGURA CLUTCH
195-347D ELECTRIC CLUTCH ADAPTOR
and three sets new:
802-684C HHCS M8X1.25X55 GR8.8
804-157C WASHER SPRING LOCK M8 PLT
Place the clutch on a work surface, tab end down.
52. Secure the large end of the 195-347D
Ogura clutch
with the bolts
and lock washers
. Torque to specifications (see page 93).
Figure 13: 2S-2600:
RH Clutch Dismount
21629
U
D
F
B
L
R
f
d
d
f
d
d
Figure 14: 2S-2600:
Disassemble RH Clutch
28108
Figure 15: 2S-2600:
Pre-assemble RH Clutch
28144
U
D
22