Great Plains Electric Clutch Package - Manual (Page 60)

56 Electric Clutch Package Great Plains Manufacturing, Inc.
195-073M 03/24/2009
Install 3S-3000F/SGS RH Clutch
Refer to Figure 89
98. Select one new:
195-349D WING FERT CLUTCH OUTER SPCR TB
Place the spacer on the right end of the drive
shaft .
99. Select one each new:
195-160H SPKT CLUTCH 40B23T RND BORE
817-111C BSHG FLG 1.26IDX1.41ODX.87L
176-065D CLUTCH FRICTION WASHER
195-222D BRG 7/8 HEX ID X 1.254 OD
With the thicker side of hub to the right, place the
sprocket
on the right end of the drive shaft .
With any flanged ends to the right, place the bushing
, the friction washer and the bearing on the
drive shaft , inside the sprocket .
100.Select the saved:
808-240C SPKT 40A23X1.813-1.818 BR/6HOL
and three sets saved:
802-551C HHCS 1/4-20X2 1/4 GR5
804-006C WASHER LOCK SPRING 1/4 PLT
Place the sprocket on the shaft , and loosely
combine it with the earlier sprocket by inserting
bolts through lock washers at every other
hole in the left face of sprocket .
101.Select one:
195-350D WING FERT CLUTCH INNER SPCR TB
Insert the spacer inside the sprocket assembly .
102.Select the clutch assembled at step 72. Place it
on the shaft , over the spacer . Rotate the
clutch until the threaded holes of the adaptor
align with the bolts
. Loosely screw in the bolts.
103.Select one each new:
196-877D BUSHING 1 1/8 ODX7/8 HEX BORE
839-956C KEY 1/4 X 3/16 X 3.80
Place bushing inside clutch . Align keyways of
bushing and Ogura clutch . Insert key
104.Select two new:
804-061C WASHER MACH 1.50 X 1.00 X 18GA
and one new:
402-025S LOCK COLLAR, 7/8 HEX W/ SET SC
which, if not pre-assembled, consists of:
1
402-058D COLLAR LOCK 7/8 HEX and
2 801-035C SCREW SET 5/16-18 SKT KP X 3/8
105.Adjust set screws to clear the collar hex hole.
Place the collar on the left end of the shaft . Do
not tighten the set screws at this time. To prevent
part loss, slide input shaft
to the right, just into
right support bearing .
106.Select three new:
805-180C PIN ROLL 1/4 X 1 1/2 LG PLT
Drive the roll pins into the empty holes of
sprocket . Tighten bolts to specification. Re-
seat roll pins as required.
Figure 89: 3S-3000F/SGS:
Install RH Clutch
28158
58
26
27
U
D
F
B
L
R
d
n
b
24
136
22
25
46
54
50
125
128
13
51
15
12
24
24
d
13
51
12
15
13 17
51 12 15
17 13
136
126
128
25 17
13
126 128
13
25
136
54
17 25
22
126
26
58
54
26 54 58
46
27
60
61
61
27 17
17
b
50
49
109 126