Update 3s-3000 center drive, Remove 3s-3000 center components, Caution – Great Plains Electric Clutch Package User Manual
Page 36
32
Electric Clutch Package
Great Plains Manufacturing, Inc.
195-073M
03/24/2009
Update 3S-3000 Center Drive
For the center section to be under independent clutch
control, the existing solid drive shaft is replaced by two
smaller shafts, coupled at the new clutch.
Remove 3S-3000 Center Components
38. Remove and save the acremeter
at the left end of
the center shaft
. Remove this instrument before
driving out any pins.
39. Loosen Drive Type idler
and lift chain (not shown)
off shaft output sprocket
remove chain.
40. Drive roll pin
out of the left end of the shaft
41. Remove and save one:
808-259C SPKT 40B14 X 7/8 HEX BORE
42. To the left of bearing
, drive roll pin
. Remove the shaft from the drill.
CAUTION
!
Washer
moves, under spring tension, about
1
⁄
2
in (13mm)
to the left as the next pin is removed.
43. To the left of washer
, drive roll pin
out of shaft
. Removal of the last pin
44. Remove from the shaft and save one each:
807-097C SPRING COMP 2 1/16 OD X 4 LG
176-066D CLUTCH SPRING RETAINER
804-061C
WASHER MACH 1.50 X 1.00 X 18GA
the removed shaft
:
195-188D POWER SHAFT 7/8 HEX CENTER
is not re-used.
Figure 51: 3S-3000:
Dismantle Center Shaft
21634
1
o
U
D
F
B
L
R
i
2
3
4
b
o
i
b
4