Great Plains Electric Clutch Package - Manual (Page 17)

Great Plains Manufacturing, Inc. Update 2S-2600 Right Hand Drive 13
03/24/2009 195-073M
Install 2S-2600 RH Clutch
Refer to Figure 16
53. Select one new:
402-025S LOCK COLLAR, 7/8 HEX W/ SET SC
which, if not pre-assembled, consists of:
1
402-058D COLLAR LOCK 7/8 HEX and
2 801-035C SCREW SET 5/16-18 SKT KP X 3/8
54. Adjust set screws to clear the collar hex hole.
Place the collar on the left end of the input shaft
. Do not tighten the set screws at this time.
55. Select two new:
804-061C WASHER MACH 1.50 X 1.00 X 18GA
Place them on the left end of the input shaft .
56. Select the clutch assembled at step 52, and one
each new:
196-877D BUSHING 1 1/8 ODX7/8 HEX BORE
839-956C KEY 1/4 X 3/16 X 3.80
Place bushing inside clutch . Align keyways of
bushing and Ogura clutch . Insert key . With
tab end to drill right, place the clutch assembly on left
end of the input shaft
.
57. Select one new:
195-348D CLUTCH SPACER TUBE
Insert it in the clutch assembly .
58. Select one each saved:
808-240C SPKT 40A23X1.813-1.818 BR/6HOL
195-170D CLUTCH ADAPTOR 7/8 HEX BORE
three sets saved:
802-551C HHCS 1/4-20X2 1/4 GR5
804-006C WASHER LOCK SPRING 1/4 PLT
Note: Note that the 195-347D has alternating smooth
and tapped (threaded)
1 ⁄
4
in holes.
59. Place the sprocket on the clutch adaptor and
align the holes. Place the adaptor on the
sprocket. Loosely insert the bolts and washers
in the threaded holes of adaptor .
60. Select three new:
805-180C PIN ROLL 1/4 X 1 1/2 LG PLT
Drive the roll pins into the smooth holes of the
195-347D . Tighten bolts to specification. Re-seat
roll pins as required.
61. Select seven (7) new:
804-061C WASHER MACH 1.50 X 1.00 X 18GA
Place them on the driven acremeter shaft .
62. Select one new:
805-180C PIN ROLL 1/4 X 1 1/2 LG PLT
Shift the input shaft to drill left, into Drive Type
chain , until the mid roll pin hole appears to the left
of the right bearing . Drive the pin into the input
shaft mid hole.
63. Shift the clutch assembly to drill left, into Drive
Type chain , until the left end of clutch has cap-
tured the right end of the acremeter shaft . Slide
collar and washers left against clutch .
Secure set screws.
Figure 16: 2S-2600:
Install RH Clutch
28147
54
58
26
50
46
U
D
F
B
L
R 27
d
s
n
b
126
128
111
136
23
22
46
50
27
60
61
61
27
d
46
d
54
26
58
54
26 54 58
d
23
22
136
111
126
128
22
136 22
111
126
128 22
50
49
22
46
s
50
d
n
b 50
d
54
n
s
27 46 54