Install 3s-4000 rh clutch – Great Plains Electric Clutch Package User Manual
Page 76
72
Electric Clutch Package
Great Plains Manufacturing, Inc.
195-073M
03/24/2009
Install 3S-4000 RH Clutch
73. Select two new:
804-061C WASHER MACH 1.50 X 1.00 X 18GA
and one new:
WING FERT CLUTCH OUTER SPCR TB
Place the washers
right end of the drive shaft
.
74. Select one saved:
195-160H SPKT CLUTCH 40B23T RND BORE
With the thicker side of hub to the right, place the
sprocket
on the right end of the drive shaft
.
If the following components are not still inside the
sprocket, insert them:
With any flanged ends to the right, place the bushing
, the friction washer
and the bearing
on
the drive shaft
, inside the sprocket
75. Select the saved:
SPKT 40A23X1.813-1.818 BR/6HOL
and three sets saved:
802-551C HHCS 1/4-20X2 1/4 GR5
804-006C WASHER LOCK SPRING 1/4 PLT
Place the sprocket
, and loosely
combine it with the earlier sprocket
by inserting
bolts
through lock washers
at every other
hole in the left face of sprocket
76. Select one:
WING FERT CLUTCH INNER SPCR TB
Insert the spacer inside the sprocket assembly
77. Select the clutch
assembled at step 72. Place it
on the shaft
, over the spacer
. Rotate the clutch
until the threaded holes of the adaptor
the bolts
. Loosely screw in the bolts.
78. Select one each new:
196-877D BUSHING 1 1/8 ODX7/8 HEX BORE
839-956C KEY 1/4 X 3/16 X 3.80
Place bushing inside clutch
. Align keyways of
bushing
and Ogura clutch
. Insert key
79. Select two new:
804-061C WASHER MACH 1.50 X 1.00 X 18GA
and one new:
402-025S LOCK COLLAR, 7/8 HEX W/ SET SC
which, if not pre-assembled, consists of:
1
402-058D COLLAR LOCK 7/8 HEX and
2
801-035C SCREW SET 5/16-18 SKT KP X 3/8
80. Adjust set screws
to clear the collar hex hole.
Place the collar
on the left end of the shaft
. Do
not tighten the set screws at this time. To prevent
part loss, slide input shaft
fully to the right, into
right support bearing
.
81. Select three new:
805-180C PIN ROLL 1/4 X 1 1/2 LG PLT
Drive the roll pins
sprocket
. Tighten bolts
to specification and
re-seat roll pins.
82. Select one new:
805-180C PIN ROLL 1/4 X 1 1/2 LG PLT
and the saved ground drive sprocket
(removed at
step 66, not shown here). With raised hub side
toward the bearing
, place sprocket
on shaft
,
and secure with roll pin
83. Shift the collar
drill left, into Drive Type chain
. Secure set screws.
Figure 116: 3S-4000:
Install RH Clutch
28145
U
D
F
B
L
R
d
n
b
d
d
d
d
d
58
d
d
b
k
b
k
d
n