3s-3000/f/sgs electrical installation, Install 3s-3000 height switch – Great Plains Electric Clutch Package User Manual
Page 63
Great Plains Manufacturing, Inc.
3S-3000/F/SGS Electrical Installation
59
03/24/2009
195-073M
3S-3000/F/SGS Electrical Installation
Install 3S-3000 Height Switch
Refer to Figure 93 (which depicts openers raised)
The electric clutch system is activated by cab switches
and by a single height switch at the center section shutoff
pivot plate
(where a mechanical linkage was
removed).
1.
Select one each new:
802-212C HHCS 3/4-10X2 1/2 GR5
and three:
804-024C WASHER FLAT 3/4 USS PLT
2.
Insert the bolt
part way into the right side of the
right pivot plate
. Add three flat washers
shown) in between the plates. Continue inserting the
bolt to retain the washers.
3.
Select one each new:
Add the switch bracket
side of the plate
. Orient the bracket extension with
the #10 slots
toward drill rear.
4.
Select one each new:
804-023C WASHER LOCK SPRING 3/4 PLT
803-027C NUT HEX 3/4-10 PLT
Secure the bracket
with a lock
washer
and nut
, finger tight. Orient the rear
edge of the bracket to approximately vertical.
5.
Select one new:
VER-28383 VERIS SPEED SNSR SWITCH HRNESS
and two sets new:
6.
Position the switch
, with the actuator arm to the
rear, and the cable up, against the left side of the
bracket
. Insert a #8 screw
(not shown)
through the switch body and bracket. Secure with flat
washer
, lock washer
and nut
7.
Select one new (not shown):
2-WIRE AMP - WEATHERPACK ADAPT
Connect the adaptor to the switch lead.
The final position of the switch is adjusted at “Adjust
Height Switch” on page 90.
Figure 93: 3S-3000/F/SGS:
Height Switch Installation
28096
x
z
x
x
44
x
z
x