Great Plains Electric Clutch Package - Manual (Page 86)

82 Electric Clutch Package Great Plains Manufacturing, Inc.
195-073M 03/24/2009
Install 3S-4000F/SGS CTR Clutch
Refer to Figure 133
51. Select one new:
402-025S LOCK COLLAR, 7/8 HEX W/ SET SC
which, if not pre-assembled, consists of:
1
402-058D COLLAR LOCK 7/8 HEX and
2 801-035C SCREW SET 5/16-18 SKT KP X 3/8
Adjust set screws to clear the collar hex hole.
Place the collar on the left end of the clutch input
shaft . Do not tighten the set screws at this time.
52. Select two new:
804-061C WASHER MACH 1.50 X 1.00 X 18GA
Place them on the input drive shaft .
53. Select the clutch assembled at step 45. Note that
the 195-347D adaptor has alternating smooth
and tapped (threaded)
1 ⁄
4
in holes.
54. Select one each new:
196-877D BUSHING 1 1/8 ODX7/8 HEX BORE
839-956C KEY 1/4 X 3/16 X 3.80
Place bushing inside clutch . Align keyways of
bushing and Ogura clutch . Insert key .
Place the clutch, tab end to right, on input shaft .
55. Select one new:
195-348D CLUTCH SPACER TUBE
Insert it in the left end of the adaptor .
56. Select one saved:
195-280H SPKT CLUTCH 40B23T 7/8HEX BORE
and three sets saved:
802-152C HHCS 1/4-20X2 GR5
804-006C WASHER LOCK SPRING 1/4 PLT
Place the hex bore sprocket on the clutch adap-
tor and align the holes. Loosely secure the bolts
and washers in the threaded holes (every
other hole) of the adaptor .
57. Select three new:
805-180C PIN ROLL 1/4 X 1 1/2 LG PLT
Drive the roll pins into the smooth holes of the
195-347D adaptor . Tighten bolts to specification.
Re-seat roll pins as necessary.
58. Select seven (7) new:
804-061C WASHER MACH 1.50 X 1.00 X 18GA
Place two on the driven shaft .
59. Select one new:
805-180C PIN ROLL 1/4 X 1 1/2 LG PLT
Shift the drive shaft to drill left, until the second of
the two left roll pin holes appears to the left of the
right bearing (one is inside the clutch). Drive the pin
into the drive shaft mid hole.
60. Shift the clutch assembly to drill left, into Fertil-
izer/Small Seeds chain (not shown), until the left end
of clutch has captured the right end of driven shaft
. Slide collar and washers left against clutch
. Secure set screws.
Figure 133: 3S-4000F/SGS:
Install CTR Clutch
28113
54
58
26
50
46
U
D
F
B
L
R
27
s
d
61
50
23
22
46
128
122
125
27
60
61
61
27
d
46
d
54
22
26
58
54
26 54 58
d
23
22
122
125
128
122
22
125 128
22
50
49
22
46
s
50
d
50 d
54
s 27 46
54