Great Plains Electric Clutch Package - Manual (Page 73)

Great Plains Manufacturing, Inc. Update 3S-4000 Right Hand Drive 69
03/24/2009 195-073M
Install 3S-4000 CTR Torque Tab
Refer to Figure 110
56. Select one new:
195-345D CLUTCH TORQUE ARM TAB
and two sets new:
802-079C HHCS 3/8-16X1 1/4 GR5
804-011C WASHER FLAT 3/8 USS PLT
804-013C WASHER LOCK SPRING 3/8 PLT
803-014C NUT HEX 3/8-16 PLT
57. Loosely mount the tab at the same bracket weld-
ment holes used by the tab removed at step
39.
58. Rotate the clutch until the torque arm is in the
large hole in the torque tab .
59. Tighten tab bolts to torque specifications.
3S-4000 Center Closeout
60. Select one new (not shown):
833-088C OGURA CLUTCH JUMPER HARNESS
Connect the jumper to the clutch cable.
Update 3S-4000 Right Hand Drive
Remove 3S-4000 RH Linkage
Refer to Figure 111 (which depicts the LH linkage, but the
parts to be removed, and their general arrangement, are
identical on the RH side)
61. Remove individually or as an assembly:
195-130H CLUTCH SHUTOFF LINK, 00 SERIES
195-144D CLUTCH SHUTOFF CAM, 00 SERIES
195-254D CLUTCH PULL TAB
805-083C PIN CLEVIS 3/4 X 1 1/2
805-109C PIN COTTER 1/8 X 1 1/4 PLT
807-072C
SPRING EXT 1 1/16 ODX.120WX5.5
These parts are not re-used.
Note: This part may be removed or left in place:
195-131H SUBFRM CLUTCH BRKT,SOLID STAND
62. Remove two sets:
802-079C HHCS 3/8-16X1 1/4 GR5
804-011C WASHER FLAT 3/8 USS PLT
804-013C WASHER LOCK SPRING 3/8 PLT
803-014C NUT HEX 3/8-16 PLT
and remove the:
152-263D CLUTCH ENGAGE TAB
These parts are not re-used.
Figure 110: 3S-4000:
Install CTR Torque Arm Tab
28148
U
D
F
B
L
R
36
54
30 20
41
42
h
t
20
30
41
42
36
20
h 101
54 t
20
30
55
106
101
124
129
130
127
134
133
132
118
108
107
U
D
F
B
L
R
Figure 111: 3S-4000:
Remove RH Linkage
17253
106
108
118
132
133
134
107
124
129
130
127
101