Replace 3s-3000 rh drive shafts, Remove 3s-3000 rh chains and input sprocket, Remove 3s-3000 rh input shaft and clutch – Great Plains Electric Clutch Package User Manual
Page 41: Remove 3s-3000 rh u-joint shaft, Install 3s-3000 solid shaft, Caution, Ef s 1 2 3
Great Plains Manufacturing, Inc.
Update 3S-3000 Right Hand Drive
37
03/24/2009
195-073M
Replace 3S-3000 RH Drive Shafts
Remove 3S-3000 RH Chains and Input Sprocket
Refer to Figure 59
79. At the Drive Type bracket, loosen idler
and lift
Drive Type drive chain
off clutch output sprocket
. Do not completely remove the chain.
80. Loosen ground drive idler (not shown) and lift ground
drive chain (not shown) off sprocket
. Do not com-
pletely remove the chain.
81. Drive right end roll pin
out of input shaft
. Pin is
not re-used.
82. Remove and save the sprocket
.
CAUTION
!
The pin removed in the next step is under lateral spring tension
from the clutch assembly. Parts of the clutch assembly will
jump to the right about
1
⁄
2
in (13mm) as the pin or punch is
withdrawn.
83. Drive out mid pin
. It is not re-used.
Remove 3S-3000 RH Input Shaft and Clutch
84. Move the shaft
to the left. Remove the:
176-042S JAW CLUTCH CW EXT 7/8 HEX
from the shafts
and
.
85. Remove the shaft
from in the drill. It is not re-
used.
Remove 3S-3000 RH U-Joint Shaft
Refer to Figure 60
86. At the left end of driven shaft
, drive out roll pin
.
The pin is not re-used.
87. Slide the right end of the U-joint
.
88. As needed, drive the mid pin
from shaft
.
Remove shaft @ from the drill. The shaft and pin are
not re-used.
Install 3S-3000 Solid Shaft
89. Select one new:
195-232D SHAFT 7/8 HEX, POINT ROW-RH
Note that the shaft has 3 pin holes. Only end holes
are used on 3S-3000, but there is a left and right
end. At the left end of the shaft, the hole is 1/2in
(12.7mm) from the end of the shaft. At the right end,
the hole is 3/8in (9.5mm) from shaft end.
Insert the right end of the shaft
bearing
and about 6in (15cm) through the mid
bearing
. Insert no pins at this time.
Figure 59: 3S-3000:
RH Chains and Input Sprocket
21631
U
D
F
B
L
R
r
i
n
d
k
f
s
i
n
k
r
d
k
f
d
d
s
d
Figure 60: 3S-3000:
Remove Driven Shaft
28156
U
D
F
B
L
R
e
f
s
1
2
3
s
e
1
s
f
s