Install 3s-3000 rh clutch – Great Plains Electric Clutch Package User Manual
Page 43
Great Plains Manufacturing, Inc.
Update 3S-3000 Right Hand Drive
39
03/24/2009
195-073M
Install 3S-3000 RH Clutch
94. Select one new:
WING FERT CLUTCH OUTER SPCR TB
Place the spacer
on the right end of the drive
shaft
.
95. Select one each new:
817-111C BSHG FLG 1.26IDX1.41ODX.87L
176-065D CLUTCH FRICTION WASHER
195-222D BRG 7/8 HEX ID X 1.254 OD
With the thicker side of hub to the right, place the
sprocket
on the right end of the drive shaft
.
With any flanged ends to the right, place the bushing
, the friction washer
and the bearing
on the
drive shaft
96. Select the saved:
SPKT 40A23X1.813-1.818 BR/6HOL
and three sets saved:
802-551C HHCS 1/4-20X2 1/4 GR5
804-006C WASHER LOCK SPRING 1/4 PLT
Place the sprocket
combine it with the earlier sprocket
by inserting
bolts
through lock washers
at every other
hole in the left face of sprocket
97. Select one:
WING FERT CLUTCH INNER SPCR TB
Insert the spacer inside the sprocket assembly
98. Select the clutch
assembled at step 72. Place it
on the shaft
, over the spacer
clutch until the threaded holes of the adaptor
align with the bolts
. Loosely screw in the bolts.
99. Select one each new:
196-877D BUSHING 1 1/8 ODX7/8 HEX BORE
839-956C KEY 1/4 X 3/16 X 3.80
Place bushing inside clutch
. Align keyways of
bushing
and Ogura clutch
. Insert key
100.Select two new:
804-061C WASHER MACH 1.50 X 1.00 X 18GA
and one new:
402-025S LOCK COLLAR, 7/8 HEX W/ SET SC
which, if not pre-assembled, consists of:
1
402-058D COLLAR LOCK 7/8 HEX and
2
801-035C SCREW SET 5/16-18 SKT KP X 3/8
101.Adjust set screws
to clear the collar hex hole.
Place the collar
on the left end of the shaft
. Do
not tighten the set screws at this time. To prevent
part loss, slide input shaft
to the right, just into
right support bearing
.
102.Select three new:
805-180C PIN ROLL 1/4 X 1 1/2 LG PLT
Drive the roll pins
sprocket
. Tighten bolts
re-seat roll pins.
Figure 63: 3S-3000:
Install RH Clutch
28158
U
D
F
B
L
R
n
b
22
58
d
b