Update 3s-3000f/sgs center drive, Remove 3s-3000f/sgs center components, Caution – Great Plains Electric Clutch Package User Manual
Page 52
48
Electric Clutch Package
Great Plains Manufacturing, Inc.
195-073M
03/24/2009
Update 3S-3000F/SGS Center Drive
For the center section to be under independent clutch
control, the existing solid drive shaft is replace by two
smaller shafts, coupled at the new clutch.
Note: Because a single kit updates 3S-3000 drills with
and without option boxes, parts for one bearing are
unused on drills with fertilizer and/or small seeds.
Remove 3S-3000F/SGS Center Components
41. Remove and save the acremeter
at the left end of
the center shaft
. Remove this instrument before
driving out any pins.
42. Loosen Drive Type idler
and lift chain (not shown)
off left end shaft output sprocket
. Loosen option
box jackshaft idler
and lift chain
off mid-shaft
output sprocket
. Do not completely remove
chains.
43. Drive roll pin
out of the left end of the shaft
44. Remove and save the left end sprocket:
808-259C SPKT 40B14 X 7/8 HEX BORE
45. To the left of bearing
, drive roll pin
. Remove the shaft to drill right. As it pass the
option box jackshaft bracket, remove another:
808-259C SPKT 40B14 X 7/8 HEX BORE
This second sprocket is
46. Remove the shaft
from the drill for further disas-
sembly.
CAUTION
!
Washer
moves, under spring tension, about
1
⁄
2
in (13mm)
to the left as the next pin is removed.
47. To the left of washer
, drive roll pin
out of shaft
. Removal of the last pin
48. Remove from the shaft and save one each:
807-097C SPRING COMP 2 1/16 OD X 4 LG
176-066D CLUTCH SPRING RETAINER
804-061C
WASHER MACH 1.50 X 1.00 X 18GA
The removed shaft:
195-188D POWER SHAFT 7/8 HEX CENTER
is not re-used.
Figure 77: 3S-3000F/SGS:
Dismantle Center Shaft
21635
1
o
U
D
F
B
L
R
i
2
3
4
b
v
u
o
i
v
u
b
4