Prepare 3s-3000f/sgs ctr driving shaft, Pre-assemble 3s-3000f/sgs ctr clutch – Great Plains Electric Clutch Package User Manual
Page 54
50
Electric Clutch Package
Great Plains Manufacturing, Inc.
195-073M
03/24/2009
Prepare 3S-3000F/SGS CTR Driving Shaft
53. Select one each new:
SHAFT 7/8 HEX,POINT ROW-CENTER
805-180C PIN ROLL 1/4 X 1 1/2 LG PLT
Note that the right end of the shaft
is the end with
3 holes. Drive the roll pin
into the hole nearest the
right end of the shaft
54. Select one each saved:
807-097C SPRING COMP 2 1/16 OD X 4 LG
176-066D CLUTCH SPRING RETAINER
804-061C
WASHER MACH 1.50 X 1.00 X 18GA
and one new:
805-180C PIN ROLL 1/4 X 1 1/2 LG PLT
55. Compress the spring
sion with some wire.
56. With the clutch jaws
toward the pinned (right)
end of the shaft
, place the clutch on the shaft.
Place the compressed spring
57. With the larger flared end of the retainer
left (away from the spring), place the retainer on the
shaft against the spring, followed by the washer
.
58. Drive the roll pin
right end of the shaft. Release the wire securing the
spring.
59. Insert the left end of the shaft through the right side
of the bearing
. Do not pin the shaft in place at this
time.
Pre-Assemble 3S-3000F/SGS CTR Clutch
60. Select one each new:
823-231C OGURA CLUTCH
195-347D ELECTRIC CLUTCH ADAPTOR
and three sets new:
802-684C HHCS M8X1.25X55 GR8.8
804-157C WASHER SPRING LOCK M8 PLT
Set the clutch assembly on a work surface, with the
torque arm end of the Ogura clutch down.
61. Secure the large end of the 195-347D adaptor
to
the Ogura clutch
with the bolts
and lock wash-
ers
. Torque to specifications.
Figure 79: 3S-3000F/SGS:
Prepare Driving Shaft
28113
U
D
F
B
L
R
b
b
Figure 80: 3S-3000F/SGS:
Pre-assemble LH Clutch
28144
U
D