Remove 3s-3000f/sgs rh u-joint shaft, Install 3s-3000f/sgs solid shaft, Disassemble 3s-3000f/sgs rh clutch – Great Plains Electric Clutch Package User Manual
Page 58: Ef s 1 2 3
54
Electric Clutch Package
Great Plains Manufacturing, Inc.
195-073M
03/24/2009
Remove 3S-3000F/SGS RH U-Joint Shaft
Refer to Figure 86
90. At the left end of driven shaft
, drive out roll pin
.
The pin is not re-used.
91. Slide the right end of the U-joint
.
92. As needed, drive the mid pin
from shaft
.
Remove shaft @ from the drill. The shaft and pin are
not re-used.
Install 3S-3000F/SGS Solid Shaft
93. Select one new:
195-232D SHAFT 7/8 HEX, POINT ROW-RH
Note that the shaft has 3 pin holes. Only end holes
are used on 3S-3000, but there is a left and right
end. At the left end of the shaft, the hole is 1/2in
(12.7mm) from the end of the shaft. At the right end,
the hole is 3/8in (9.5mm) from shaft end.
Insert the right end of the shaft
bearing
and about 6in (15cm) through the mid
bearing
. Insert no pins at this time.
Disassemble 3S-3000F/SGS RH Clutch
94. From the clutch assembly
, remove and save
three sets:
802-152C HHCS 1/4-20X2 GR5
804-006C WASHER LOCK SPRING 1/4 PLT
The sprockets
may still be held
together, and on the clutch
, by roll pins.
95. Remove and sprockets:
SPKT 40A23X1.813-1.818 BR/6HOL
Any roll pins present, the hex bore sprocket
the balance of the clutch assembly
used.
Figure 86: 3S-3000F/SGS:
Remove Driven Shaft
28156
U
D
F
B
L
R
e
f
s
1
2
3
s
e
1
s
f
s
Figure 87: 3S-3000F/SGS:
Disassemble RH Clutch
16452