Dell POWEREDGE M1000E - Manual (Page 1071)

Configuring IPv6 Routing 1071
Configuring IPv6 Routing Features (CLI)
This section provides information about the commands you use to configure
IPv6 routing on the switch. For more information about the commands, see
the PowerConnect M6220/M6348/M8024/M8024-k CLI Reference Guide at
support.dell.com/manuals .
Configuring Global IP Routing Settings
Beginning in Privileged EXEC mode, use the following commands to
configure various global IP routing settings for the switch.
Command Purpose
configure Enter global configuration mode.
ipv6 unicast-routing Globally enable IPv6 routing on the switch.
ipv6 hop-limit limit Set the TTL value for the router. The valid range is 0 to
255
ipv6 icmp error-interval
burst-interval [burst-
size]
Limit the rate at which IPv4 ICMP error messages are sent.
• burst-interval — How often the token bucket is
initialized (Range: 0–2147483647 milliseconds).
• burst-size — The maximum number of messages that
can be sent during a burst interval (Range: 1–200).
exit Exit to Privileged EXEC mode.
show ipv6 brief View the global IPv6 settings for the switch.