Configuring and viewing pim-dm for ipv6, Multicast routing – Dell POWEREDGE M1000E User Manual
Page 1216
1216
Managing IPv4 and IPv6 Multicast
Configuring and Viewing PIM-DM for IPv6 Multicast Routing
Beginning in Privileged EXEC mode, use the following commands to
configure PIM-DM for IPv6 multicast routing on the switch and on VLAN
routing interfaces and to view PIM-DM information.
Command
Purpose
configure
Enter global configuration mode.
ipv6 pim dense
Enable PIM-DM on the switch.
interface vlan
vlan-id
Enter Interface Configuration mode for the
specified VLAN.
ipv6 pimdm
Enable PIM-DM on the interface.
ipv6 pimdm hello-interval
seconds
Specify the number of seconds (range: 0–65535)
to wait between sending PIM hello messages on
the interface.
exit
Exit to Privileged EXEC mode.
show ipv6 pim
View system-wide PIM-DM information.
show ipv6 pimdm interface vlan
vlan-id
View the PIM-DM information for the specified
interface.
show ipv6 pimdm neighbor
[interface vlan
vlan-id | all]
View a summary or all the details of the multicast
table.