Dell POWEREDGE M1000E - Manual (Page 162)

162 Managing a Switch Stack
Preconfiguring a Stack Member
To preconfigure a stack member before connecting the physical unit to the
stack, use the show support switchtype command to obtain the SID of the
unit to be added.
The example in this section demonstrates pre-configuring a PowerConnect
7048P switch on a stand-alone PowerConnect 7048R switch.
To configure the switch:
1 View the list of SIDs to determine which SID identifies the switch to
preconfigure.
console#show supported switchtype
2 Preconfigure the 7048P switch (SID = 6) as member number 2 in the
stack.
console#configure
console(config)#stack
console(config-stack)#member 2 6
console(config-stack)#exit
console(config)#exit
SID Switch Mode ID Code Type
------ ------------------------- ----------
1 PCM6348 0x100b000
2 PCT7024 0x100b000
3 PCT7024P 0x100b000
4 PCT7024F 0x100b000
5 PCT7048 0x100b000
6 PCT7048P 0x100b000
7 PCT7048R 0x100b000
8 PCT7048R-RA 0x100b000