Configuring auto voip (cli) – Dell POWEREDGE M1000E User Manual
Page 1147
Configuring Auto VoIP
1147
Configuring Auto VoIP (CLI)
This section provides information about the commands you use to configure
Auto VoIP settings on the switch. For more information about the
commands, see the
PowerConnect M6220/M6348/M8024/M8024-k CLI
Reference Guide
.
Mapping Table Configuration
Beginning in Privileged Exec mode, use the following commands in to enable
Auto VoIP and view its configuration.
CLI Command
Description
configure
Enter Global Configuration mode.
switchport voice detect auto
Enable the VoIP Profile on all the interfaces of the
switch. You can also enter Interface Configuration
mode and use the same command to enable it on a
specific interface.
exit
Exit to Global Configuration Exec mode.
exit
Exit to Privilege Exec mode.
show switchport voice
Show the status of Auto-VoIP on all interfaces or on
an interface, if one is specified.