Dell POWEREDGE M1000E - Manual (Page 484)

484 Configuring a Captive Portal
block (Optional) Block all traffic for a Captive Portal
configuration. If the Captive Portal is blocked, users
cannot gain access to the network through the Captive
Portal. Use this function to temporarily protect the
network during unexpected events, such as denial of
service attacks.
CTRL + Z Exit to Privileged EXEC mode.
show captive-portal
configuration cp-id
[status | interface]
View summary information about a Captive Portal
instance.
• cp-id — The Captive Portal instance (Range: 1–10).
• status — View additional information about the Captive
Portal instance.
• interface — View information about the interface(s)
associated with the specified Captive Portal.
show captive-portal
interface configuration
cp-id status
View information about the interfaces associated with the
specified Captive Portal instance.
cp-id — The Captive Portal instance (Range: 1–10).
NOTE: To return the default Captive Portal instance to its default values, use the
clear command in the Captive Portal Instance mode. You must also use the no
interface interface command to remove any associated interfaces from the
instance.
Command Purpose