Dell POWEREDGE M1000E - Manual (Page 562)

562 Configuring Access Control Lists
Configuring ACLs (CLI)
This section provides information about the commands you use to create and
configure ACLs. For more information about the commands, see the
PowerConnect M6220/M6348/M8024/M8024-k CLI Reference Guide at
support.dell.com/manuals .
Configuring an IPv4 ACL
Beginning in Privileged EXEC mode, use the following commands to create
an IPv4 ACL, configure rules for the ACL, and bind the ACL to an interface.
NOTE: The ip access-group command can be issued in Global Configuration
mode or Interface configuration mode. If it is applied in Global Configuration
mode, the ACL binding is applied to all interfaces. If it is applied in Interface
Configuration mode, it is applied only to the specified interfaces within the mode.
Command Purpose
configure Enter global configuration mode.
access-list name {deny |
permit} {every | {[icmp
| igmp | ip | tcp | udp |
number] {srcip srcmask
| any} [eq [ portkey |
portvalue]] {dstip
dstmask | any} [eq
[portkey | portvalue]]
[precedence precedence
| tos tos tosmask | dscp
dscp] [log] [time-range
time-range-name]
[assign-queue queue-id]
[redirect interface |
mirror interface]}}
Create a named ACL (if it does not already exist) and
create a rule for the named ACL. If the ACL already exists,
this command creates a new rule for the ACL.
• list-name — Access-list name up to 31 characters in
length.
• deny | permit — Specifies whether the IP ACL rule
permits or denies an action.
• every — Allows all protocols.
• eq — Equal. Refers to the Layer 4 port number being
used as match criteria. The first reference is source match
criteria, the second is destination match criteria.
• number — Standard protocol number. Protocol keywords
icmp, igmp, ip, tcp, udp.
• srcip — Source IP address.
• srcmask — Source IP mask.
• dstip — Destination IP address.
• dstmask — Destination IP mask.