Dell POWEREDGE M1000E - Manual (Page 567)

Configuring Access Control Lists 567
(Continued) • destination ipv6 prefix — IPv6 prefix in IPv6 global
address format.
• flow label value — The value to match in the Flow Label
field of the IPv6 header (Range 0–1048575).
• dscp dscp — Specifies the TOS for an IPv6 ACL rule
depending on a match of DSCP values using the
parameter dscp.
• log — Specifies that this rule is to be logged.
•
time-range-name — Specifies the named time range to
associate with the ACL rule.
• assign-queue queue-id — Specifies particular hardware
queue for handling traffic that matches the rule.
• mirror interface — Allows the traffic matching this rule
to be copied to the specified interface.
• redirect interface — This parameter allows the traffic
matching this rule to be forwarded to the specified
interface.
interface interface (Optional) Enter interface configuration mode for the
specified interface. The interface variable includes the
interface type and number, for example gigabitethernet
1/0/3.
You can also specify a range of interfaces with the interface
range command, for example, interface range
gigabitethernet 1/0/8-12 configures interfaces 8, 9, 10, 11,
and 12.
ipv6 traffic-filter name
direction [sequence seq-
num]
Bind the specified IPv6 ACL to an interface.
NOTE: To apply this ACL to all interfaces, issue the command
in Global Configuration mode.
• name — Access list name. (Range: Valid IPv6 access-list
name up to 31 characters in length)
• direction — Direction of the ACL. (Range: In or out.
Default is in.)
• seqnum — Precedence for this interface and direction. A
lower sequence number has higher precedence. Range: 1
– 4294967295. Default is1.
Command Purpose