Dell POWEREDGE M1000E - Manual (Page 868)

868 Configuring Routing Interfaces
ip local-proxy-arp Enable local proxy ARP on the interface to allow the
switch to respond to ARP requests for hosts on the same
subnet as the ARP source.
ip mtu size Set the IP Maximum Transmission Unit (MTU) on a
routing interface. The IP MTU is the size of the largest
IP packet that can be transmitted on the interface
without fragmentation. The range is 68–9198 bytes.
bandwidth size Set the configured bandwidth on this interface to
communicate the speed of the interface to higher level
protocols. OSPF uses the bandwidth value to compute
link cost. The range is 1–10000000.
ip unreachables Allow the switch to send ICMP Destination
Unreachable messages in response to packets received
on the interface.
ip redirects Allow the switch to send ICMP Redirect messages in
response to packets received on the interface.
exit Exit to Global Config mode.
ip default-gateway
ip_address
Configure the default gateway. All switch interfaces use
the same default gateway.
exit Exit to Privileged EXEC mode.
show dhcp lease [interface
interface]
View information about the DHCP leases acquired for
all interfaces or for the specified interface.
For a VLAN, the
interface_string parameter is vlan
followed by the VLAN ID, with no space, for example
vlan10.
show ip interface vlan vlan-
id
View the IP interface configuration information for the
specified routing VLAN.
Command Purpose