Dell POWEREDGE M1000E - Manual (Page 357)

Configuring SNMP 357
snmp-server v3-host { ip-
address | hostname}
username {traps |
informs} [noauth | auth
| priv] [timeout
seconds] [retries retries]
[udpport port] [filter
filtername]
For SNMPv3, configure the system to receive SNMP traps
or informs.
• ip-address — Specifies the IP address of the host
(targeted recipient).
• hostname — Specifies the name of the host. (Range: 1-
158 characters.)
• username — Specifies user name used to generate the
notification. (Range: 1-25 characters.)
• traps — Indicates that SNMP traps are sent to this host.
• informs — Indicates that SNMPv2 informs are sent to
this host.
• noauth — Specifies sending of a packet without
authentication.
• auth — Specifies authentication of a packet without
encrypting it
• priv — Specifies authentication and encryption of a
packet.
• seconds — Number of seconds to wait for an
acknowledgment before resending informs. This is not
allowed for hosts configured to send traps. The default is
15 seconds. (Range: 1-300 seconds.)
• retries — Maximum number of times to resend an inform
request. This is not allowed for hosts configured to send
traps. The default is 3 attempts. (Range: 0-255 retries.)
• port — UDP port of the host to use. The default is 162.
(Range: 1-65535.)
• filter-name — Specifies the optional filter (defined with
the snmp-server filter command) to use for the host.
(Range: 1-30 characters.)
exit Exit to Privileged EXEC mode.
show trapflags View the status of the configurable SNMP traps.
Command Purpose