Dell POWEREDGE M1000E - Manual (Page 821)

Snooping and Inspecting Traffic 821
ip dhcp snooping limit
{none | rate rate [burst
interval seconds]}
Configure the maximum rate of DHCP messages allowed
on the switch at any given time.
• rate—The maximum number of packets per second
allowed (Range: 0–300 pps).
• seconds—The time allowed for a burst (Range: 1–15
seconds).
interface interface Enter interface configuration mode for the specified port
or LAG. The interface variable includes the interface type
and number, for example gigabitethernet 1/0/3. For a
LAG, the interface type is port-channel.
You can also specify a range of ports with the interface
range command, for example, interface range
gigabitethernet 1/0/8-12 configures interfaces 8, 9, 10, 11,
and 12.
ip dhcp snooping trust Configure the interface (or range of interfaces) as a trusted
port. DHCP server messages are not filtered on trusted
ports.
exit Exit to Global Configuration mode.
interface [range] vlan
vlan id
Enter interface configuration mode for the specified
VLAN or range of VLANs.
ip dhcp snooping Enable DHCP snooping on the VLAN(s).
CTRL + Z Exit to Privileged EXEC mode.
show ip dhcp snooping
[interfaces]
View the DHCP snooping global and per port
configuration.
show ip dhcp snooping
binding [{static |
dynamic}] [interface
port] [vlan vlan-id]
View the entries in the DHCP snooping bindings database.
show ip dhcp snooping
database
View information about the persistent database
configuration.
show ip dhcp snooping
statistics
View the DHCP snooping statistics.
clear ip dhcp snooping
statistics
Reset the DHCP snooping statistics to zero.
Command Purpose