Configuring cos (cli), Mapping table configuration – Dell POWEREDGE M1000E User Manual
Page 1137
Configuring Class-of-Service
1137
Configuring CoS (CLI)
This section provides information about the commands you use to configure
CoS settings on the switch. For more information about the commands, see
the
PowerConnect M6220/M6348/M8024/M8024-k CLI Reference Guide
at
.
Mapping Table Configuration
Beginning in Privileged Exec mode, use the following commands in to
configure the CoS mapping tables.
CLI Command
Description
configure
Enter Global Configuration mode.
interface
interface
Enter Interface Configuration mode, where
interface is replaced by gigabitethernet
unit/slot/port, tengigabitethernet unit/slot/port, or
port-channel
port-channel number.
classofservice dotlp-mapping
priority
Map an 802.1p priority to an internal traffic class for
a switch. You can also use this command in Global
Configuration mode to configure the same
mappings on all interfaces.
classofservice trust {dot1p |
ip-dscp | untrusted}
Set the class of service trust mode of an interface.
exit
Exit to Global Config mode.
exit
Exit to Privilege Exec mode.
show classofservice dotlp-
mapping
Display the current Dot1p (802.1p) priority
mapping to internal traffic classes for a specific
interface.
show classofservice ip-dscp-
mapping
Display the current IP DSCP mapping to internal
traffic classes for a specific interface.
show classofservice trust
Display the current trust mode setting for a specific
interface.