Default auto configuration values – Dell POWEREDGE M1000E User Manual
Page 394
394
Auto Image and Configuration Update
Default Auto Configuration Values
Table 14-3 describes the Auto Configuration defaults.
Table 14-3. Auto Configuration Defaults
Feature
Default
Description
Auto Install
Mode
Enabled
When the switch boots and no saved configuration is
found, the Auto Configuration automatically begins.
Retry Count
3
When the DHCP or BootP server returns information
about the TFTP server and bootfile, the switch makes
three unicast TFTP requests for the specified bootfile. If
the unicast attempts fail or if a TFTP server address was
not provided, the switch makes three broadcast requests
to any available TFTP server for the specified bootfile.
AutoSave
Disabled
If the switch is successfully auto-configured, the
running configuration is not saved to the startup
configuration.
AutoReboot
Enabled
After an image is successfully downloaded during the
Auto Configuration process, the switch automatically
reboots and makes the downloaded image the active
image.