Dell POWEREDGE M1000E - Manual (Page 757)

Configuring L2 Multicast Features 757
Configuring IGMP Snooping Querier
Beginning in Privileged EXEC mode, use the following commands to
configure IGMP snooping querier settings on the switch and on VLANs.
CTRL + Z Exit to Privileged EXEC mode.
show ip igmp snooping
vlan vlan-id
View the IGMP snooping settings on the VLAN.
Command Purpose
configure Enter global configuration mode.
ip igmp snooping querier
[vlan vlan-id] [address
ip-address]
Enable the IGMP snooping querier on the switch or on
the VLAN specified with the vlan-id parameter.
Use the optional ip-address parameter to specify the IP
address that the snooping querier switch should use as the
source address when generating periodic queries.
ip igmp snooping querier
query-interval interval-
count
Set the IGMP snooping querier query interval time, which
is the amount of time in seconds that the switch waits
before sending another periodic query. The range is
1–1800 seconds.
ip igmp snooping querier
timer expiry seconds
Set the IGMP snooping querier timer expiration period.
This is the time period, in seconds, that the switch
remains in non-querier mode after it has discovered that
there is a multicast querier in the network.
ip igmp snooping querier
version version
Set the IGMP version of the query that the switch sends
periodically. The version range is 1–2.
vlan database Enter VLAN Configuration mode.
ip igmp snooping querier
vlan-id
Enable the IGMP snooping querier on the specified
VLAN.
Command Purpose