FaxBack NET SatisFAXtion 8.6 - Manual - Manual (Page 177)

4 – Appendices NET SatisFAXtion 8.6 Manual 177
4325 Conversion application did not respond to DDE command in
a timely fashion: A request for a synchronous execute transaction has timed
out.
DMLERR_EXECACKTIMEOUT
4326 Invalid DDE parameter: A parameter failed to be validated by the
DDEML. DMLERR_INVALIDPARAMETER
4327 The conversion application has used too much memor y
during DDE: A DDEML application has created a prolonged race condition (in
which the server application outruns the client), causing large amounts of
memory to be consumed.
DMLERR_LOW_MEMORY
4328 DDE memor y allocation has failed: DMLERR_MEMORY_ERROR
4329 DDE transaction failed communicating with conversion
application: Conversion application does not support DDE: Conversion
application does not support DDE.
DMLERR_NOTPROCESSED
4330 Conversion application does not suppor t DDE: A client’s
attempt to establish a conversation has failed. DMLERR_NO_CONV_ESTABLISHED
4331 A request for a synchronous poke transaction has timed out:
DMLERR_POKEACKTIMEOUT
4332 The DDE system failed calling its internal PostMessage
function: DMLERR_POSTMSG_FAILED
4333 Attempted reentrant DDE call: An application instance with a
synchronous transaction already in progress attempted to initiate another
synchronous transaction, or the
DdeEnableCallback function was called from
within a DDEML callback function. DMLERR_REENTRANCY
4334 The conversion application terminated during a DDE
command: A server-side transaction was attempted on a conversation
terminated by the client, or the server terminated before completing a
transaction.
DMLERR_SERVER_DIED
4335 The DDE system failed due to unspecified internal error:
DMLERR_SYS_ERROR
4336 DDE timeout attempting to terminate an advise transaction:
DMLERR_UNADVACKTIMEOUT
4337 DDE invalid transaction identifier: An invalid transaction identifier
was passed to a DDEML function. Once the application has returned from an
XTYP_XACT_COMPLETE callback, the transaction identifier for that callback
function is no longer valid. DMLERR_UNFOUND_QUEUE_ID
4.1.2
1032–1140: Class 1 Driver
1071 Bad open ring 0 / kernel mode driver: There is another instance
of the Class1 driver already loaded, or the Windows account attempting to load
the driver does not have Administrative permissions.
1087 No modem response: The modem did not respond to any
commands. Check cabling or if this is a PCI card modem, check that the card is
properly seated. Also try shutting the server down, leaving it off for 60 seconds,
and powering it back on. Error type:
NON_RETRYABLE .
1088 Invalid response from modem: The modem sent a response not
allowed by the Class 1 specification. Error type: NON_RETRYABLE .