2 strip digits from front or back of did, 4 csid routing, 5 caller id / ani routing – FaxBack NET SatisFAXtion 8.6 - Manual User Manual
Page 48: 6 t.30 subaddress routing, 7 inbound routing capabilities by device, 1 audiocodes mediapack, mediant, and trunkpack
2 – Server Administration
NET SatisFAXtion 8.6 Manual
48
2.5.1.3.2
Strip Digits from Front or Back of DID
With some PBXs or VoIP systems, there are more digits provided in the DID than
are desired.
When using AudioCodes equipment, see Protocol Configuration ► Manipulation
Tables in the web interface of the AudioCodes device.
To strip a fixed length of digits from the front (left) of a number, set the following
registry key. Note that in Administration and Reports the full string will still be
visible, but this many digits will be ignored for routing purposes.
[HKEY_LOCAL_MACHINE\SOFTWARE\FaxBack\CASDrive]
"DtmfRouteStripCount" = <NumberToStrip>
To strip digits from the end (right) of a number, configure the number of DTMF
digits collected to be less than the full digit string being sent from the PBX.
2.5.1.4
CSID Routing
Prone to failure.
Disabled by default. To enable:
[HKLM\Software\FaxBack\CasDrive]
"RouteOnCsid" = "1"
2.5.1.5
Caller ID / ANI Routing
Prone to failure.
Disabled by default. To enable:
[HKLM\Software\FaxBack\CasDrive]
"RouteOnAniCallerId" = "1"
2.5.1.6
T.30 Subaddress Routing
The T.30 fax specification allows an additional identifier to be specified by the
sender for routing purposes. This feature was never widely implemented when it
was first introduced, and is almost never implemented today.
Disabled by default. To enable:
[HKLM\Software\FaxBack\CasDrive]
"RouteOnT30SubAddress" = "1"
"SubAddressSeparator" = "#"
Subaddress is transmitted via a T.30 HDLC SUB frame, 20 characters in length.
The allowed chars for SUB are numbers, space, *, and #”.
2.5.1.7
Inbound Routing Capabilities By Device
2.5.1.7.1
AudioCodes MediaPack, Mediant, and TrunkPack
AudioCodes MediaPacks (FXO ports) are capable of routing on Line or DTMF.
AudioCodes MediaPacks (FXS ports) are DID Trunk capable, and can route on
DNIS.
AudioCodes TrunkPack (TP260) cards, Mediant 1000s with T1/PRI cards,
Mediant 2000 and 3000 gateways are capable of routing on DNIS. No
additional configuration is necessary.