FaxBack NET SatisFAXtion 8.6 - Manual - Manual (Page 219)

4 – Appendices NET SatisFAXtion 8.6 Manual 219
init_string [string]: This is the basic modem initialization string. It should reset
the modem and init the required flow control. Format: Up to 80 characters.
Default:
&F&C1&D2V1E0S0=0S7=90^^ .
All modem commands start with AT, so this string does not need AT. The
symbols in the string mean the following:
^ 2-second pause
\ Carriage return. There is a wait of
init_string_timeout_msecs after carriage return to wait an OK to be
returned.
\\ Specifies a single \
^^\ this is interpreted as \^^
init_string_timeout_msecs [dword 0–65535]: How long to wait for
response after
CR in the init_string if there are no 2-second pauses before or
after the CR . Default: 5000 .
io_buf fer_size [dword 0–65535]: This is the size of the image buffer. The
necessary buffer size depends on host CPU speed and load as well as connect
speed. This buffer directly adds to driver page locked memory use so should be
as small as possible. However, too small a buffer will cause faxes to fail. Default:
20480 .
show_console_scroll_back_buffer_size [dword 0–4294967295]: When
the debug output is
CONSOLE , this is how big of a buffer to be used for scrollback.
Default: 282144 .
show_ring0_buffer_size [dword 0–4294967295 ]: How big of buffer for the
page locked debug buffer that ring0 code writes to and ring3 code extracts from
(on a thread) to the debugging output. This should be larger for when using
serial capture mode since so much more data is written for debug. It should
probably be only about 1K for when using T.30 debug since the frequency and
amount of T.30 debug is small enough that the ring3 code can easily keep up
writing to the show output. Default:
65536 .
debug_show_file_path [string(256)]: Partial path or complete path and file
name of where to create debug file. If the debug_show_output is set for
CONSOLE and the debug_show_file_path is specified in the registry, then you
can get both CONSOLE and FILE debug output simultaneously. This is a device
specific setting, but you can set the default for all devices by specifying this
under the global icanfax section.
csid [string(20)]: The CSI for receive and the TSI for send.
allowed_receive_image_types [string]: These settings control the image
types that the device can send and receive via the T.30 protocol over the
telephone network. To receive or send some image types, the corresponding
allowed_receive / send_transfer_type setting must include ECM. Format:
Comma separated list of the following. Default: 1D,2D,T6,JBIG .
1D
2D
T6
JPEG
JBIG
COLOR
200H_400V
300H_300V
400H_400V